Industrial pump controllers

Sewage pump controller

Industrial pump controllers

• SIMPLEX
• DUPLEX
• TRIPLEX

Sewage pump controllers are installed to automatically start and stop pump motor(s) in order to remove liquid accumulated in a sump pit or sewage lift station. Automatic level control is provided by start and stop float switches. Automatic alternation is provided on duplex and triplex sewage pump controllers.

The completely assembled and wired controllers are factory tested before shipping. All components used in Tornatech sewage pump controllers are CSA listed and UL approved.

Tornatech favors fuseless motor protection for easy field maintenance.

Standard Features	Simplex	Duplex	Triplex
NEMA/CSA 1 enclosure ASA 61 grey	1	1	1
Main disconnect switch (HP rated) c/w door interlocked handle	1	1	1
Thermomagnetic motor protector(s)(Overload & Short circuit protection)*	1	2	3
Across-the-line contactor(s) (HP rated)	1	2	3
Control transformer 120V. secondary c/w secondary fuse	1	1	1
"Power On" white pilot light	1	1	1
"Run" green pilot light(s)	1	2	3
"Hand-Off-Auto" selector switch(es)	1	2	3
Provision to connect float switches (float swiches not included)	2	3	4
Automatic transfer to non operating pump in case of motor overload or short circuit	N/A	1	1
Automatic pump alternation	N/A	2 pumps	3 pumps

* Replaced by single pole circuit breaker(s) and overload relay(s) in single phase controllers.

Sewage Pump Data Sheet (1209K)